What sets this area apart
Ardhiya Industrial contains warehouses and factories with wide foundations and thick concrete floors spanning very large areas. Voids beneath these floors are filled with foam concrete to minimise settlement and unevenness, especially where drainage pipes or buried electrical networks run underneath. Foam density is chosen by expected load and ranges from 500 to 1000 kilograms per cubic metre. Continuous, rapid pumping is critical because large spans require simultaneous pouring to avoid a construction joint that would weaken the base.
Ardhiya Industrial is in Farwaniya governorate, a dense industrial zone with warehouses and production shops.
Continuous pumping of foam concrete must cover the entire floor area without breaks to avoid weak construction joints.
What the work covers
Mixed, pumped and finished across roofs, floors, voids and utility trenches in Kuwaiti buildings
Roof levelling layer
Forms drainage falls on flat roofs without adding heavy dead load
Void and cavity fill
Fills under-slab voids, pipe trenches and old tunnels at low pressure
Lightweight floor base
Balances floor levels below screed while reducing load on the structural slab
Service trench backfill
Stable, non-migrating backfill around electrical conduits and drainage pipes
Insulating fill layer
Low density provides partial thermal benefit under Kuwait's intense roof heat
Post-demolition fill
Fills gaps left after removing old services or non-structural demolished elements
How it works.
Call or whatsApp
Describe the location, approximate area and purpose of the foam concrete layer
Site visit
We visit, measure the area, check surface condition and assess pump access
Mix spec and quote
We set the density and strength grade then submit a written quotation
Preparation and pour
Surface prepared, foam mixed to spec, poured and spread to the required level
Finish and handover
Level and density checked after setting, site handed over ready for the next trade
Why one contractor beats four.
Every extra contractor means another schedule and another excuse. With us, one company answers for all of it.
Turnkey
Shell and finishing with one company, from footings to keys.
Pay in instalments
Construction and finishing on instalments. Ask us for the details.
Engineering supervision
Architectural drawings and engineering supervision on site.
After handover
Maintenance contracts and a 24-hour emergency plumber.
A licensed Kuwaiti company for building construction, finishing, renovation and infrastructure works.
What our clients say.
See all reviews on GoogleExcellent
Taha Saad
Google review
Excellent
Ali Nadi
Google review
More areas for Foam concrete
Other services in Ardhiya Industrial
Questions about Foam concrete in Ardhiya Industrial
Call nowDo you fill the large voids beneath factory floors with foam concrete?
Yes, and large voids require continuous, rapid pumping to prevent the mix from setting before the entire area is filled. We bring multiple mixer trucks and pump lines to ensure no flow interruption.
How do you choose foam concrete density for floors bearing heavy loads?
We determine density from the consultant engineer's load calculations, ranging from 500 to 1000 kilograms per cubic metre. Higher density provides greater compressive strength but adds slightly more weight.
Licensed and registered in Kuwait.
Check us before you sign. This is our licence number and what it covers.
Find us on Google Maps