Herringbone parquet in Sharq
Herringbone parquet installation in Sharq demands tight angle cuts and snug piece-fit on level floors. We start with floor levelling and centre-line marking, then bond planks in a crisp crossed pattern and finish with sanding and full clean-down.
- Licensed company
- Turnkey builds
- Pay in instalments
- All 6 governorates
What sets this area apart
Sharq has older villas with uneven concrete subfloors and modern apartment blocks with flat ceilings. In older villas we lay a levelling screed first to reach the required level before parquet goes down, while newer blocks allow direct installation if the concrete is flat. The herringbone pattern needs precise angled cuts at corners and outer edges, especially around columns and doorways, and a mis-cut plank means replacing the whole piece.
Sharq sits in Capital governorate and overlooks the Gulf, where residential villas and commercial towers mix near Kuwait Towers.
We check floor flatness with a laser level before starting; deviation must not exceed 3 mm per square metre.
What the installation covers
From floor levelling and centre-line layout through bonding, trimming and final cleaning
Substrate levelling
Detecting and filling low spots before any board is placed
Centre-line layout
Marking axis lines so the pattern stays symmetrical across the room
45-degree angle cutting
Cutting each piece accurately to produce a clean herringbone chevron
Adhesive bonding
Spreading adhesive fully under each piece and pressing it flush
Border and edge cuts
Precise trimming at walls and thresholds to close the pattern neatly
Sanding and finishing
Light sanding and a protective coat on solid boards after bonding
How it works.
Call or whatsApp
Tell us the area and your preferred wood type
Site inspection
We measure and check the substrate level and moisture condition
Quotation
A detailed quote covering materials, labour and any levelling needed
Installation
Levelling, centre-line layout, then precise bonding and cutting throughout
Inspection and handover
Every board is checked and any hollow spots are pressed before handover
Why one contractor beats four.
Every extra contractor means another schedule and another excuse. With us, one company answers for all of it.
Turnkey
Shell and finishing with one company, from footings to keys.
Pay in instalments
Construction and finishing on instalments. Ask us for the details.
Engineering supervision
Architectural drawings and engineering supervision on site.
After handover
Maintenance contracts and a 24-hour emergency plumber.
A licensed Kuwaiti company for building construction, finishing, renovation and infrastructure works.
What our clients say.
See all reviews on GoogleExcellent
Taha Saad
Google review
Excellent
Ali Nadi
Google review
More areas for Herringbone parquet
Other services in Sharq
Questions about Herringbone parquet in Sharq
Call nowDoes an old villa floor need levelling before herringbone parquet?
Yes, older concrete floors are often uneven. We apply a self-levelling screed or raise with cement mortar, then verify flatness with a laser before parquet bonding starts.
How do you cut parquet precisely at corners and columns?
We use a fine-toothed 45-degree mitre saw and measure each corner on site, then cut on a dedicated bench before bonding. Precision is critical because a mis-cut plank must be replaced entirely.
Licensed and registered in Kuwait.
Check us before you sign. This is our licence number and what it covers.
Find us on Google Maps